Project Description

Joystick transmitter

Nano-magna Ex

The Nano-magna Ex offers all the advantages of the Nano-magna and can be used without any problems in offshore areas in zones 1 and 2 with gas explosion hazards.

  • Maximum number of control elements possible
  • Also suitable for extremely complex applications
  • Low weight despite the size
  • Optional: 4.3 inch LC display with customised design
  • SMJ Technology
  • Operation with two rechargeable batteries possible, therefore up to 15 hours without interruption
FAITES VOTRE DEMANDE MAINTENANT!
FICHE TECHNIQUE
Frequency range 419 MHz / 429 MHz / 434 MHz / 868 MHz / 915 MHz / 2,4 GHz
(depending on customer requirements and country-specific regulations)
RF power ≤ 10 mW
Typical working range ≤ 100 m
(depending on environmental conditions)
Frequency channel search, automatic LBT-Modus (Listen Before Talk)
(depending on country and function configuration)
Antenna Integrated
Typical response time of control commands Approx. 50 ms
LF modulation method FSK / GFSK (SubGHz) / O-QPSK (2,4 GHz)
Data rate 9.600 Baud (Bit/sec) at SubGHz 250 k at 2.4 GHz
SMJ-Technology Joysticks can be replaced by the operator in case of service;
exception MSA3.
Ø Current consumption (depending on the expansion level) With LC display: approx. 250 mA
Prewarning time “Battery empty” Approx. 15 minutes
Acoustic response
LC/TFT display Optional: 4.3 inch graphic TFT color display (480 x 272 px), customized illustration possible
Energy saving function (Standby) Standard: after 60 min.
Optional: setting according to customer requirements (continuous operation possible)
Ambient operating temperature -20 °C to +50 °C
Weight 2.900 g
Dimensions (L x W x H) 354 mm x 229 mm x 170 mm
Case material Impact resistant, glass fiber reinforced polyamide
Status display (7-segment, depending on the configuration) 1x (2-digit)
CE certification Yes
IP-Protection class IP65
Data security Addressing of each transmitter by unique bit combination
EMERGENCY STOP or STOP function (sending stop telegrams for 2 sec.) Yes
Power supply NiMH battery (7.2 VDC / 1,800 mAh), pluggable
Operation time Up to 15 hours
Loading form Externally, via a separate charger
Automatic battery compartment switching Yes
Charger available for (UE) 110 VAC – 230 VAC, 12/24 VDC
Plug form AC (adapter Set) EU, USA, JP, GB, AU
Plug form DC Car charger plug

Data feedback

– Reach
– Transmitting signal strength
– Status of the machine function
– Customer-specific feedback information and logos on request

LBT frequency search

When switching on or switching to another frequency, the system checks whether the frequency channel used is occupied by other transmitters. If this is the case, the next frequency channel is checked until it is ensured that the transmitter can operate without interference. LBT is the abbreviation for ‘Listen before Talk’.

Design as cable desk

For radio-critical work areas, the control unit can be supplied on request, not as a transmitter but as a cable console with the same functional equipment.

Practical carrying system

Standard:
– Abdominal belt (order no.: 3.320.1016)

– Back carrying strap (order no.: 3.320.1015)

La description

The explosion-protected Nano-magna Ex joystick transmitter can be used in zones 1 and 2 with gas explosion hazards. This makes it the perfect transmitter in the offshore area.

The Nano-magna Ex is the largest representative of our explosion-protected safety radio remote controls. The particularly large housing offers space for the maximum number of operating elements such as up to 8 single-axis and 4 two-axis joysticks. In addition, toggle switches, rotary switches and buttons can also be integrated. Due to the multitude of possibilities and control elements, the Nano-magna is also suitable for extremely complex applications.

On request, the Nano-magna Ex can be equipped with a 4.3 inch LC display – including integration of the customer-specific design. The high-resolution display shows the information that is necessary for you and the safety of your employees. Turn the Nano-magna into your wireless remote control and place your logo on the back of the display!

Thanks to the patented SMJ technology, the joysticks can be replaced by operators themselves during service. The exchange is so easy that no staff training or special tools are required! The housing remains closed throughout, so that no protective measures against contamination need to be taken. Thanks to this patented technology, the complete system is completely ready for use again with just a few simple steps.

Technologie

SMJ

Les joysticks montés en surface sont intégrés dans les boîtiers de nos émetteurs sans ouverture de boîtier. Comme les joysticks font partie des pièces d’usure sous certaines conditions, la technologie SMJ NBB vous offre la possibilité de changer un joystick sur place. Il n’est pas nécessaire d’ouvrir le boîtier à cette fin, de sorte qu’aucune mesure de protection contre la contamination ne doit être prise. [Plus d’informations]

NBB IECEx ATEX

IECEx / ATEX

Si les émetteurs doivent être utilisés dans des environnements potentiellement explosifs, des précautions techniques appropriées doivent être prises. Les émetteurs Planar-B1 et -B2 EX ont été spécialement développés et certifiés pour de telles applications. [Plus d’informations]

Fonction d'apprentissage

La fonction d’« apprentissage » permet une utilisation optimale de la course du joystick. En réglant les valeurs min/max du côté de l’émetteur, la trajectoire disponible du joystick est utilisée de manière optimale. Cela signifie qu’il n’y a plus de course morte du joystick. Même une déviation minime du joystick a un effet immédiat. [Plus d’informations]

multi_user_system_technologie-nbb_funkfernsteuerungen

Système multi-utilisateurs

Le système multi-utilisateurs permet la communication radio entre plusieurs émetteurs et récepteurs. Chaque émetteur peut éventuellement fonctionner avec plusieurs récepteurs sur un même poste de travail et/ou inversement. À condition que la connexion sélectionnée ne soit pas utilisée à d’autres fins à ce moment-là. [Plus d’informations]

NBB Akkusystem

Système de batterie NBB

Les batteries au nickel-hydrure métallique (NiMH) de NBB ont une densité énergétique élevée. Avec un chargeur NBB, les batteries sont chargées à un courant de charge élevé. Cette charge rapide est contrôlée thermiquement pour optimiser la recharge et éviter la surcharge. [Plus d’informations]

Radiokey

Radiokey

La RADIOKEY fournit à l’opérateur de la grue ou de la machine une zone définie dans laquelle il peut activer la télécommande radio. Une activation inconsciente ou erronée de l’émetteur est donc exclue et aucune information de contrôle n’est transmise au récepteur. Cela réduit considérablement le risque de sécurité. [Plus d’informations]

LBT-Frequenzsuche

Recherche de fréquences LBT

LBT est l’abréviation de « Listen before Talk » (écouter avant de parler). Lorsque l’émetteur est allumé ou lorsque la fréquence est modifiée, on vérifie si le canal de fréquence utilisé est occupé par d’autres émetteurs. Le cas échéant, le canal de fréquence suivant est automatiquement vérifié jusqu’à ce qu’il soit garanti que l’émetteur peut fonctionner sans interférence. [Plus d’informations]

Daten-rückmeldung

Retour d'informations

Sur tous nos canaux, diverses informations peuvent être affichées visuellement : Puissance du signal de transmission, état de fonctionnement de la machine ou informations et logos spécifiques au client. Ils peuvent également être complétés par des signaux de retour acoustique (un buzzer peut être activé). [Plus d’informations]

Applications

Offshore Krane

Grues offshore

Ölplattform

Plates-formes pétrolières

Tanklaster

Camion-citerne